Overview
The
Saginaw Control & Engineering SCE-1210CHSNF is a continuous hinge enclosure that can serve as a junction box, terminal enclosure, or control box. Its 0.063-inch carbon steel body has an ANSI-61 gray powder-coated finish. Its 5-inch depth suits a shallower component layout. 10" H × 12.13" W × 5" DContinuous HingeIP66
The enclosure has no factory holes or knockouts. Continuously welded, ground-smooth seams and an oil-resistant door gasket help protect enclosed electrical components. The continuous hinge runs along the shorter side of the enclosure and uses stainless steel hinge pins.
💡 Plan Cable Entry Around Your Layout
With no holes or knockouts, the enclosure leaves cable entry locations to be determined during installation. Plan openings and sealing methods around the components and required environmental rating.
Key Features
- Continuous hinge along the shorter side with stainless steel hinge pins
- Two outside screw clamps secure the door
- Oil-resistant gasket at the door opening
- Continuously welded seams ground smooth
- No holes or knockouts in the enclosure
- Ground studs on both door and body
✅ Choose the Right Size
The 10" H × 12.13" W × 5" D enclosure provides a defined footprint for terminals or controls. Confirm space for components, wiring bends, and the planned back-mounted installation.
Installation Notes
Mounting provisions are welded to the rear at the top and bottom. Standoffs are provided for mounting subpanels, which are sold separately. Plan all field-made openings so the required enclosure rating is maintained.
⚠️ Type 3R Installation Note
Special IS3, IS4, and IS6 instructions apply to maintain the Type 3R environmental rating. Follow the instructions on the enclosure door.
