Saginaw SCE-9PBHI Hinged Push Button Enclosure, 9 Position, 22.5mm

Saginaw Control & Engineering SCE-9PBHI is a 9 position hinged push button enclosure. It is made from 0.063" carbon steel with an ANSI-61 gray powder coating and 22.5mm pushbutton entrances in a 3x3 configuration. Designed for keeping oil-tight push buttons, switches, and pilot lights protected from dirt & moisture. (See link to applicable push buttons below)

• 10.13" H x 10" W x 6" D (257.3mm x 254mm x 152.4mm)
• Continuously welded seams
• Cover screws thread into sealed wells
• Continuous bolt-on hinge with stainless steel hinge pin
• Works with any brand of oil-tight push buttons, switches, or pilot lights
• 4 way standard push button entrance
• Gasket is oil & water resistant
• Welded mounting plates located on the back at the top and bottom
• Powder coating on both the inside and outside
• Ground stud on door
• Sub-panel supported by standoffs (sold separately)
• IS2 industry standards - NEMA Type 4, 12 and Type 13, UL Listed Type 4 and 12, CSA Type 4 and 12, IEC 60529, IP 66

22mm Push Buttons

Industrial Enclosure & Junction Box Selector