Home > Panel Meters > PAX Lite 1/8 DIN Panel Meters >

Red Lion PAXLPV00 Process Volt Panel Meter

Red Lion Process Volt Panel Meter
Red Lion PAXLPV00 Process Volt Panel Meter

Alternative Views:

Our Price: $239.00
MFG: Red Lion
Weight (lbs): 0.65

Product Code: PAXLPV00


The Red Lion PAXLPV00 PAX LPV Lite series process time panel meter has a 3 1/2 digit, red LED display in a 1/8 DIN housing. This panel meter can be applied to most instances where readouts for flow, temperature, pressure, and level are needed. It is made to be used under harsh conditions, including dirty environments and wash down areas. When voltage is in the negative, the display can show a minus sign. AC powered.


  • 1/8 DIN Housing
  • 3 1/2 Digit, Red LED Display
  • 24 VDC Excitation Supply
  • Wide Span & Offset Scaling Range (covers 1 to 5 VDC process input)
  • Over Range Indication
  • Selectable Decimal Points
  • +/- 25 Volt DC Maximum Input
  • NEMA 4X/IP65 - Front Panel

Red Lion PAX LPV Lite Series User Manual


3-1/2 digit, 0.56" (14.2 mm) red LEDs
Power Requirements
AC Power: 85 to 250 VAC, 50/60 HZ, 6 VA
Isolation: 2300 Vrms for 1 min. to all inputs.
Input Sensitivity: Adjustable from 40 units/volt to 1000 units/volt. Max.
allowable input voltage, +/-25 volts DC
Input Resistance: 1 M Ohm
Linearity: +/-(0.05% +/-1 digit)
Reading Rate: 2.5 updated readings / second, nominal.
Response Time: 1 second to settle for step change.
Low Frequency Noise Rejection
Normal Mode Rejection: 63 dB @ 50/60 Hz
Common Mode Rejection: 100 dB, DC to 50/60 Hz
Excitation Supply: 24 VDC @ 50 mA max. Regulated and isolated
Standards Compliance
UL Recognized Component, File # E179259, UL61010A-1, CSA C22.2 No. 61010-1
UL Listed, File # E137808, UL508, CSA C22.2 No. 14-M95
Type 4X Enclosure rating (Face only), UL50
IECEE CB Scheme Test Certificate # US/8843A/UL
IECEE CB Scheme Test Report # 04ME11209-20041018
IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment
for measurement, control, and laboratory use, Part 1.
IP65 Enclosure rating (Face only), IEC 529
IP20 Enclosure rating (Rear of unit), IEC 529
Electromagnetic Compatibility: See user manual
Operating Temperature: 0 C to 60 C (32 F to 140 F)
Storage Temperature: -40 C to 80 C (-40 F to 176 F)
Humidity: 85% max. relative humidity (non-condensing)
Span Temperature Coeff.: 100 PPM/°C
Offset Temperature Coeff.: 100 PPM/°C
Vibration to IEC 68-2-6: Operational 5 to 150 Hz, in X, Y, Z direction for 1.5 hours, 2 g's.
Shock to IEC 68-2-27: Operational 30 g, 11 msec in 3 directions
Altitude: Up to 2000 meters
Construction: NEMA 4X/IP65 indoor use, IP20 Touch safe, Installation Category II,
Pollution Degree 2, One piece bezel/case; flame resistant;
panel gasket & mounting clip
Connection: High Compression Cage-Clamp Terminal Block
Wire Strip Length: 0.3" (7.5 mm)
Wire Gage: 30-14 AWG copper wire
Torque: 4.5 inch-lbs (0.51 N-m) max.
Dimensions: 1.95" x 3.8" x 4.2"

PAXLPV00 Process Volt Panel Meter

Additional Product Information

Panel Meter Comparison Chart