Mencom Panel Interface Connector Part Number Guide

Mencom Panel Interface Connector Part Number Guide

Build a panel interface connector part number or decode an existing number to review its options. Search Products for Automation when your configuration is complete.

Note: Not all options are available for every type of Mencom Panel Interface Connector.

Choose your options

Choose each field. Use the additional communication port field if you need a second port type.

No options selected.

The guide assembles option codes; it does not confirm that a combination is manufactured or in stock. Verify the complete configuration on the product page before ordering.

No search results? Email our customer service team at [email protected] with your part number for assistance.

View All Part Number Options

Order: Prefix → Power → D-Sub → Communication → Reset → Housing. DH joins the first code directly. LP1, LP2, and LP3 are separated with a dash. LS, when selected, joins the housing size directly.

Explanations of Options

GFCI receptacle: Ground Fault Circuit Interrupter. Offers protection from electrical shock and features test and reset buttons.

Simplex receptacle: One outlet.

Duplex receptacle: Two outlets.

D-Sub: D-Subminiature. The high-density 15-pin version has three rows of five pins. The standard 15-pin version has two rows: one with eight pins and one with seven pins.

Exterior / interior: Describes the connection on the outside of the panel and the connection inside the enclosure.

Housing Size Base Dimensions

Base dimensions by housing size. Inch dimensions are approximate.
Size Millimeters Inches
6 80.4 mm × 45.5 mm 3.2" × 1.8"
10 93.5 mm × 45.5 mm 3.7" × 1.8"
16 113.5 mm × 45.5 mm 4.5" × 1.8"
24 142.5 mm × 45.5 mm 5.6" × 1.8"
32 126 mm × 92 mm 5" × 3.6"
48 168 mm × 93 mm 6.6" × 3.7"