 |
 |
 |
|
The Red Lion PAXLPT00 PAX LPT Lite series process time panel meter has a 6 digit, red LED display in a 1/8 DIN housing.
It is made to indicate the amount of time between the start and end of a process. The display operates inversely to the input signal. For example, when input frequency increases, the amount on the display decreases to show that the process is taking less time. This panel meter accommodates sensors from magnetic pickups, logic sensors, NPN open collector sensors, and switch contact closure sensors. The front panel features 3 programming keys. AC powered.
Features
- 1/8 DIN Housing
- 6 Digit, Red LED Display
- 999999 or 999-59 Display Modes
- Input Rates up to 25 KHz
- Accepts a Variety of Sensors
- Programmable Scaling
- Programmable Decimal Points
- NEMA 4X/IP65 - Front Panel
Red Lion PAX LPT Lite Series User Manual
Specifications
Display
6 digit, 0.56" (14.2 mm) red LEDs
Power Requirements
AC Power: 115 or 230 VAC, switch selectable. Allowable power line variation
+/-10%, 50/60 Hz, 6 VA.
Isolation: 2300 Vrms for 1 min. to input and DC Out/In
DC Power: 10 to 16 VDC @ 0.1 A max.
Sensor Power: 9 to 17.5 VDC @ 100 mA max.
Input
Logic State: Active Low
Input trigger levels VIL = 1.5 V max.; VIH = 3.75 V min.
Current Sinking: Internal 7.8 KOhm pull-up to +12 VDC, IMAX = 1.9 mA
Current Sourcing: Internal 3.9 KOhm pull-down, 8 mA max. @ 30 VDC max.
MAGNETIC PICK-UP:
Sensitivity: 200 mV peak
Hysteresis: 100 mV
Input impedance: 3.9KOhm @ 60 Hz
Maximum input voltage: +/-40 V peak, 30 Vrms
Input Frequency Range:
Max Frequency: 25 KHz
Min Frequency: 0.05 Hz
Accuracy: +/-0.02%
Memory: Nonvolatile E2PROM retains all programmable parameters
Standards Compliance
UL Recognized Component, File # E179259, UL61010A-1, CSA C22.2 No. 61010-1
UL Listed, File # E137808, UL508, CSA C22.2 No. 14-M95
Type 4X Enclosure rating (Face only), UL50
IECEE CB Scheme Test Report # 04ME11209-20041018
IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment
for measurement, control, and laboratory use, Part 1.
IP65 Enclosure rating (Face only), IEC 529
IP20 Enclosure rating (Rear of unit), IEC 529
Electromagnetic Compatibility: See user manual
Physical
Operating Temperature: 0 C to 60 C (32 F to 140 F)
Storage Temperature: -40 C to 60 C (-40 F to 140 F)
Humidity: 85% max. relative humidity (non-condensing)
Vibration to IEC 68-2-6: Operational 5 to 150 Hz, in X, Y, Z direction for 1.5 hours, 2 g's.
Shock to IEC 68-2-27: Operational 30 g, 11 msec in 3 directions
Altitude: Up to 2000 meters
Construction: NEMA 4X/IP65 outdoor use, IP20 Touch safe, Installation Category II,
Pollution Degree 2, One piece bezel/case; flame resistant; Synthetic rubber keypad,
panel gasket & mounting clip
Connection: High Compression Cage-Clamp Terminal Block
Wire Strip Length: 0.3" (7.5 mm)
Wire Gage: 30-14 AWG copper wire
Torque: 4.5 inch-lbs (0.51 N-m) max.
Dimensions: 1.95" x 3.8" x 4.2"
PAXLPT00 Process Time Panel Meter
|
|
|
 |
|
 |
|