Home > Fan Filter Assemblies >

Fandis TRT-10A230V-NO Bimetallic Celsius Thermostat, Normally Open

Fandis Mechanical Thermostat
Fandis TRT-10A230V-NO Bimetallic Celsius Thermostat, Normally Open


 
Alternative Views:


Price: $17.50
MFG P/N: TRT-10A230V-NO
MFG: Fandis
Weight (lbs): 0.12



Availability:
Currently Unavailable
Product Code: 3981000
Not Currently Available

Description Technical Specs Instructions & Manuals
 

The Fandis TRT-10A230V-NO 110-250 Vac bimetallic sensor thermostat is used to control the temperature inside enclosures and control cabinets. This normally open thermostat is used to switch a cabinet fan on at a pre-set maximum temperature limit, therefore replacing the warm air with cooler ambient air. The Fandis TRT-10A230V-NO thermostat works for heating, cooling or switching signal equipment. Comes in Celsius scale.

Note: This product is no longer available and has been replaced with Seifert 301120

  • Narrow on/off switching range
  • Wide temperature range
  • Innovative fixing system to accommodate 3 sizes of DIN rail (15, 32, 35)
  • Standard color RAL 7035
  • Housing in self extinguishing PA66 according to UL 94V-O
  • IP20 protection degree
  • Screw terminals for electrical connection
  • Bimetallic sensing element
  • External knob for setting 5 C indexing
  • Storage temperature: -40 C to 90 C
  • Contact endurance over 100,000 cycles
  • UL (Underwriters Laboratories) approved, according to UL 873

Voltage Rated Current Contact Current Carrying Capacity Setting Range Net Weight Storage Temp Range
(V) (A) (A) (°C) (Ounces) (°C)
110-250 a.c. 10 15 -10 to 80 1.9 -40 to 90

Fandis Bimetallic Celsius Thermostat, Normally Open

Additional Product Information
The temperature can be easily set simply by dialing the knob. Because it is normally open, the contact on the thermostat stays open as long as the temperature is below the preset limit. It closes when the temperature goes above that limit. The contact opens again once the temperature goes back down. The TRT-10A230V-NO thermostat should be installed in a position away from vibration, direct sunlight, or extreme heat or cold.